Is it easy to make curved jewelry showcase? How long does it take?
Curved jewelry showcase in some jewelry stores is very easy to see, it is relatively strong sense of design compared to some common showcase, but some friends are also curious about it, such as is it easy to make? So the following to tell you about its production part of some of the content.
Must be molded
Curved jewelry showcase is a relatively special kind of showcase. Most of the production of the showcase directly cut plate splicing can be, but this kind of showcase in the production before must be open a mold, otherwise in the subsequent production process is very easy to occur problems, especially some details part, in the opening of the mold need to pay much attention to avoid deviations.
The production of relatively high difficulty
The production of curved jewelry showcase may be more difficult in a few of the showcase. Its production difficulty is much higher than our common right angle type showcase production. In the production process of a little deviation may lead to later design problems, so it needs to be operated by more experienced masters.
Relatively long time consuming
Because of the need to open the mold, so the pre-preparation time is relatively long, and the subsequent production process on the details and the specific size of the grasp requirements are very high, so the overall production time is also relatively long, so you want to make a curved jewelry display cabinet need a relatively long time, and you need to contact the production manufacturers in advance.